MULTI-USE INTERCHANGEABLE CARTRIDGES
Whatever your support system requirements; various strut channel sizes, clevis hangers or steel-angles, Insuguard Multi™ got you covered! Its revolutionary design allows you to instantly switch from one to the other within seconds!
Thanks to its interchangeable clipping cartridges, one saddle can be adapted to any suspension system.
ALL CARTRIDGES FIT ANY SIZE OF SADDLE.
CLEVIS HANGERS - TOOL-FREE, FAST INSTALLATION
Time is money! Insuguard Multi™’s Clevis adaptor saves 40% installation time! See the video that proves it.
Insert saddle inside the Clevis hanger, then a simple ‘’Click’’ is all it takes to insert the cartridge that locks the saddle with its clevis hanger. The saddle is now secured in place while pipes are being installed or insulated. Both the cartridge door and the lock-in guides make it impossible for saddle to move or twist. This feature is what allows the insulated pipes to move freely inside the saddle (not with the saddle) when thermal expansion comes in effect.
STEEL ANGLE - TOOL-FREE, FAST INSTALLATION
Insuguard Multi™’s steel angle mount adaptor saves 60-70% installation time! See the video that proves it.
Just “clip” cartridge inside saddle, put in on top of steel-angle and “zip” the blade down until secured on steel-angle inside corner.
The saddle is now secured in place while pipes are being installed or insulated.
STRUT CHANNELS - TOOL-FREE, FAST INSTALLATION
Insuguard Multi™’s strut mount adaptors saves 50-80% installation time! See the video that proves it.
Just “clip” desired channel size of cartridge inside saddle then clip on strut, that’s it! The saddle is now secured in place while pipes are being installed or insulated.
See the specification sheet for all 5 strut size cartridges available.
SLIDING LIP DESIGN
Insulation damage is common at the end of traditional saddles.
Their sharp edges attack the insulation when it moves.
Thanks to the Insuguard Multi™ lip design, it allows free lateral movement of piping at both ends, without damaging its insulation-EVER!
The inside surface of the Insuguard Multi™ is equipped with a special texture(MT-11030) that allows the pipes and their insulation to move freely, within the saddle.
The texture’s design acts as micro bubbles to create a thin film of air between the saddle and the insulation to accommodate movement of the pipes generated by thermal expansion and vibration.
The insulation tear-off problem is a thing of the past!
In the eventuality that a UniCover™ should be needed, the Insuguard Multi™ is equipped with matching notches to quickly adapt to it.
Click here for more info on UniCover™.
A professional installation is what shows your customers how carefully and seriously you take interest in their project.
Click here for more pictures of installations.